AC Installation in Irving - One Written Price, Rebates Handled

Fast, Reliable AC Installation Across Irving

A new AC system in Irving typically runs $3,500 to $7,500 for a full central installation, and our crews reach most Irving neighborhoods the same day you call. We know the housing stock here, from the 1960s tract homes south of Highway 183 to the garden apartments off Valley View Lane and MacArthur Boulevard. That local knowledge means we size the system right the first time, not to a rule of thumb that works in Plano but not in Las Colinas. If you need AC Installation in Irving, call (430) 213-5796 and we’ll give you a written price before any work starts.

Call (430) 213-5796

Why Cold Harbour Heating and Air Dallas Is Irving’s Preferred AC Installation Company

We’ve been serving Irving homeowners and apartment managers since 2003, and the jobs we see here don’t look like the jobs in Dallas or Addison. Irving’s housing is denser. Over half the housing units are multi-family, which means rooftop packaged units, closet air handlers, and tight access that a crew has to plan around. Our techs show up knowing that a Valley View Lane apartment complex may have a rooftop crane requirement, while a 1970s ranch off Belt Line Road might have a closet air handler that was never meant to hold modern equipment. That’s the difference between an install that passes inspection and one that ends up as a second visit.

Victor Mancini, who leads our Irving installs, has spent years diagnosing the specific failure modes this city produces: mineral-clogged condensate lines, oversized 1980s condensers that short-cycle, and attic heat that bakes undersized ductwork. We also handle Furnace Repair in Irving when heating systems fail in winter. When you call, a live person answers, 24 hours a day. When we schedule, we give you a firm window. And when we hand you a written price, it does not change at the door. That’s The Kingswell Way, put in writing every time.

Ductless Mini Split Installation in Irving

Ductless Mini Split Installation in Irving is the right answer for a specific kind of home: the older tract house or apartment unit where original galvanized ductwork is too leaky to justify a full central system, or where there’s simply no attic space to run new ducts. A mini split system delivers cooling directly from a wall-mounted indoor unit to a small outdoor condenser, connected by a slim conduit through an exterior wall. In Irving, a full ductless install runs $3,500 to $7,500 depending on how many indoor heads you need and the electrical work required. For a 1980s townhome off Rochelle Boulevard that never had central air, a two-zone mini split often costs less than trying to retrofit ductwork and hits the comfort target faster.

We install Daikin, Bryant, and American Standard mini split systems, all sized to the actual room loads, not a generic square-footage guess. The written price includes the line set, the condensate drain line routed away from your foundation, the electrical disconnect, and the thermostat or remote. You get a written guarantee on the install, and if anything fails inside 365 days, we come back to Irving and correct it at no charge.

When a mini split beats central air

If your Irving home has hot spots in a converted garage or a second-story room that never cools, a mini split solves that one zone without touching existing ducts. Apartment dwellers in Las Colinas often use single-zone mini splits for the same reason: the HOA won’t approve central work, but a small wall-mounted unit passes review.

Apartment and condo install rules

Many Irving multi-family buildings have noise curfews and require the condenser to sit on a vibration pad away from bedroom windows. We measure static pressure and bracket vibration during the install, so you don’t get a neighbor complaint and then a building violation letter. It’s the kind of detail that keeps a mini split legal and quiet.

AC Replacement in Irving

AC Replacement in Irving means pulling out an old system before it dies completely in an August heat wave, and matching the new equipment to the actual load of your home. Too many Irving homes built in the 1980s have original oversized condensers that short-cycle, kill compressors early, and never dehumidify properly. A replacement condenser and evaporator coil in Irving runs $3,500 to $7,500, and a full system with new ductwork or a heat pump will land in the upper half of that range. We never replace a unit without running a load calculation on the actual structure, including window orientation, insulation, and that brutal western exposure off DFW Airport’s reflected heat.

The job involves recovering the old refrigerant (removing and capturing the cooling fluid so it doesn’t vent into the air), swapping the outdoor unit and indoor coil, brazing the line set, pulling a vacuum, and correcting the refrigerant charge to the manufacturer’s spec. We also replace the filter drier and check the condensate drain line, because in Irving’s humid summers, a neglected drain line will flood a closet air handler within weeks. Every replacement carries the AC Installation written guarantee: 365 days, if our work fails, we return and fix it free.

Signs your Irving AC needs replacement now

If your system is over 12 years old, running an 8-SEER efficiency rating, and you’ve already spent $600 this season on repairs, a replacement usually cost-justifies itself. In Irving’s older neighborhoods south of 183, we regularly find rusted secondary heat exchangers and mismatched coils that were never paired correctly at the original install. Those systems are done.

What we check before quoting

We check the condition of the existing line set, the electrical panel capacity, the duct static pressure, and the condensate drain routing. On multi-family rooftop units, we also confirm crane access and the building’s noise policy before we give you a written number. No surprises, no change orders at the curb.

Trusted Brands We Service in Irving

Our Irving install crews work on all the major residential brands, including Carrier repair in Irving, and we routinely install full systems from Carrollton to Grand Prairie, so we keep a deep stock of local parts and equipment. That means a replacement doesn’t wait on a shipment from the East Coast. If your existing system is a Trane, Lennox, Rheem, or Goodman, we can service it; if it’s time for new equipment, we’ll quote you an American Standard, Daikin, or Bryant system sized to your home. We do not push one brand. We push the right fit for your ductwork, your load, and your warranty needs. And every brand we install is backed by our written 365-Day Done Right Promise, issued before the technician leaves your Irving property.

Common AC Installation Problems We See in Irving Homes

• Condensate drain lines clogging within weeks. Irving’s humidity, the lake effect from Lake Carolyn, and the Trinity River basin create rapid algae growth in drain lines. We route drains with cleanouts and, where needed, install condensate pumps with an overflow shutoff switch so a clog floods a closet, not your hallway.
• Oversized original units from the 1980s short-cycling heat exchangers. Many south Irving tract homes still have original 4-ton condensers cooling 1,400 square feet that only needs a 2.5-ton load. Those oversized units cycle on and off every few minutes, soak the compressor, and crack heat exchangers. We re-run the load calculation on every install, period.
• Rooftop installations that fail inspection on static pressure. Multi-family buildings off Valley View Lane and Story Road often have long duct runs that were never balanced. When a rooftop packaged unit is replaced without taking static pressure measurements, the new blower pushes air hard enough to whistle and rattle neighbors. We measure, then install.
• Corroded evaporator coils from hard Trinity River water. Irving’s municipal water is hard, and the vapor adds mineral deposition on coils and inside condensate pans. We see coils six years old that look fifteen. We fit secondary drain pans with mineral-tolerant float switches and recommend coil coatings on systems near the Trinity basin.

Pricing for AC Installation in Irving, TX

We Also Serve Cities Near Irving

We serve Irving and the surrounding area, including Dallas, DeSoto, Sunnyvale, and Addison. If you’re in one of those cities, our dispatchers route the nearest Irving-based tech, and the same written pricing and 365-Day Done Right Promise apply. For details, see our AC Installation in Irving page or call (430) 213-5796.

FAQs About AC Installation in Irving